• CSCD核心中文核心科技核心
  • RCCSE(A+)公路运输高质量期刊T1
  • Ei CompendexScopusWJCI
  • EBSCOPж(AJ)JST
二维码
监控与维护

一种控制隧道排水系统结晶堵塞的新型除垢剂研发与性能研究

  • 胡家玮 ,
  • 王聪 ,
  • 雷广军 ,
  • 温波
展开
  • (1. 兰州理工大学, 甘肃 兰州 730050; 2. 甘肃公航旅路业有限公司, 甘肃 兰州 730070)
胡家玮(1982—),男,甘肃兰州人,2014年毕业于北京工业大学,市政工程专业,博士,副教授,现从事水处理新技术研发与应用工作。E-mail: hujiawei@lut.edu.cn。

网络出版日期: 2023-12-08

Development and Performance of a Novel Cleaner for Controlling Crystallization Clogging in Tunnel Drainage System

  • HU Jiawei ,
  • WANG Cong ,
  • LEI Guangjun ,
  • WEN Bo
Expand
  • (1. Lanzhou University of Technology, Lanzhou 730050, Gansu, China;  2. Gansu Public Air Travel Road Co., Ltd., Lanzhou 730070, Gansu, China)

Online published: 2023-12-08

摘要

为解决在全球范围内普遍存在的隧道结晶问题,研究一种新型除垢剂。通过采集隧道结晶垢样可知,水样中Ca2+、Mg2+、CO32-、SO42-的含量较低,HCO3-含量较高,以及弱碱性环境是结晶形成的主要原因;使用能谱分析和扫描电镜表征其组成和微观结构可知,隧道结晶物的主要成分是方解石型的碳酸钙。选用模拟实验装置来研究水样/除垢剂质量比对除垢速率的影响,通过主剂、辅剂相结合的方式,利用响应面方法优化除垢剂配方,并进行腐蚀性和溶解性的安全性检测。研究结果表明: 1)最佳配比为质量分数为7.5%~8.5%的氨基磺酸、0.2%~0.8%的DTPMPA和0.2%~0.8%的PBTCA; 2)经实验室模拟验证,除垢率为85%~99.8%,并可根据实际情况调整除垢剂配比以满足不同环境下的除垢要求。

本文引用格式

胡家玮 , 王聪 , 雷广军 , 温波 . 一种控制隧道排水系统结晶堵塞的新型除垢剂研发与性能研究[J]. 隧道建设, 2023 , 43(11) : 1973 -1983 . DOI: 10.3973/j.issn.2096-4498.2023.11.017

Abstract

A novel cleaner specifically designed to mitigate crystallizationinduced clogging in tunnel drainage systems is introduced. Analysis of the tunnel crystal samples reveals low concentrations of Ca2+, Mg2+, CO32-, and SO42-and a notably high average concentration of HCO3-. This high HCO3- concentration signifies a predominantly weak alkaline environment, which was identified as the primary cause of crystallization. Utilizing energy spectrum analysis and scanning electron microscopy, the composition and microstructure of the tunnel crystal are characterized, establishing calcitetype calcium carbonate as its primary component. To assess the effectiveness of the cleaner, a simulated experimental device was employed to explore the impact of the water samplecleaner mass ratio on the cleaning rate. To optimize the formulation of the cleaner, the response surface method is employed by combining the main and auxiliary agents. In addition, safety tests for corrosion and solubility were conducted. The results unveil the following key findings: (1) The most effective mixing proportions comprise 7.5%~8.5% sulfonic acid, 0.2%~0.8% DTPMPA, and 0.2%~0.8% PBTCA. (2) The indoor simulations exhibit a cleaning rate fluctuating between 85% and 99.8%. Adjusting the proportions of materials according to different environmental conditions is essential for achieving an optimal cleaning effect.

文章导航

/

〈 〉