• 中国科学引文数据库(CSCD)来源期刊
  • 中文核心期刊中文科技核心期刊
  • Scopus RCCSE中国核心学术期刊
  • 美国EBSCO数据库 俄罗斯《文摘杂志》
  • 《日本科学技术振兴机构数据库(中国)》
二维码

隧道建设(中英文) ›› 2016, Vol. 36 ›› Issue (11): 1332-1336.DOI: 10.3973/j.issn.1672-741X.2016.11.007

• 研究与探索 • 上一篇    下一篇

基于圆形断面的隧道温度场有限差分计算模型

周小涵1,2, 曾艳华1,*, 白赟1, 魏英杰3, 何省4   

  1. (1. 西南交通大学交通隧道工程教育部重点实验室, 四川 成都 610031; 2. 中铁大桥勘测设计院集团有限公司, 湖北 武汉 430050; 3. 成都建筑工程集团总公司, 四川 成都 610014;4. 中国中铁二院工程集团有限责任公司, 四川 成都 610031)
  • 收稿日期:2016-02-03 修回日期:2016-10-31 出版日期:2016-11-20 发布日期:2016-11-30
  • 作者简介:周小涵(1988—),男,重庆忠县人,西南交通大学桥梁与隧道工程专业在读博士,从事大型交通隧道的防灾救援技术和地铁结构研究。Email: zhouxh2008@126.com。*通讯作者: 曾艳华, Email: zengyhua@163.com。
  • 基金资助:

    国家自然科学基金资助项目(51278426)

Finite Difference Calculation Model for Tunnel Temperature Field Based on Circular Crosssection

ZHOU Xiaohan1, 2, ZENG Yanhua1,*, BAI Yun1, WEI Yingjie3, HE Xing4   

  1. (1.Key Laboratory of Transportation Tunnel Engineering of Ministry of Education, Southwest Jiaotong University,  Chengdu 610031, Sichuan, China; 2.China Railway Major Bridge Reconnaissance & Design Institute Co., Ltd.,  Wuhan 430050, Hubei, China; 3.Chengdu Construction Engineering Group Corporation,Chengdu 610014,  Sichuan, China; 4.China Raiway Eryuan Engineering Group Co., Ltd., Chengdu 610031, Sichuan, China)
  • Received:2016-02-03 Revised:2016-10-31 Online:2016-11-20 Published:2016-11-30

摘要:

除了少数圆形隧道外,大部分山岭交通隧道断面采用马蹄形或端墙式等形状。在隧道温度场的预测中,圆形断面模型能否代替马蹄形等实际隧道模型,其适应性值得研究。应用基于空气-衬砌-围岩的对流-导热耦合作用控制方程的有限差分方法,建立圆形断面模型对东北寒区马蹄形隧道温度场进行计算,并与现场实测温度场进行对比。结果表明: 1) 圆形断面隧道模型有限差分计算方法克服了通用有限元软件建模复杂、对硬件要求高的弊端,考虑了隧道内风流速度和入口风流温度的影响,在隧道温度场的预测计算中能够满足工程使用要求。2)隧道内风流速度和入口风流温度对隧道温度场影响较大。本文算例中,入口风流温度每升高10 ℃,二次衬砌表面温度升高约7.2 ℃,增幅均匀;从1~5 m/s,洞内风流速度每增大1 m/s,二次衬砌表面温度降低的幅度为6.6、2.7、1.5、0.9 ℃,降幅越来越小。

关键词: 马蹄形隧道, 圆形隧道, 温度场, 有限差分, 现场实测, 风流温度, 风流速度

Abstract:

The horseshoeshaped tunnels and end wall type tunnels are common in mountain areas. It’s necessary to study the suitability of tunnel temperature field calculation model using circular crosssection. The temperature fields of cold region horseshoeshaped tunnels in Northeast China are calculated by circular crosssection model using finite difference method of convectionconduction equations based on airliningsurrounding rock. The calculation results are compared with measured data. The results show that: 1) The finite difference calculation method by using circular crosssection model and considering effects of wind flow velocity and wind flow temperature, is easy and convenient; it can meet the construction requirements. 2) The wind flow velocity in tunnel and wind flow field at tunnel portal have a significant influence on tunnel temperature field. The temperature of secondary lining surface increases by 7.2 ℃ when wind flow temperature at tunnel portal increases by 10 ℃ . The temperature of secondary lining surface reduces by 6.6 ℃, 2.7 ℃, 1.5 ℃ and 0.9 ℃ when the wind flow velocity is 2 m/s, 3 m/s, 4 m/s and 5 m/s respectively.

Key words: horseshoeshaped tunnel, circular tunnel, temperature field, finite difference, field monitoring, wind flow temperature, wind flow velocity

中图分类号: