Fracturing of an Artificial Rock Mass by Open-Ended Microwave and Potential Benefits to Assisted Mechanical Excavation(开放式微波致裂模拟节理岩体试验及辅助破岩评估)

doi:10.3973/j.issn.2096-4498.2023.08.008

隧道建设（中英文） ›› 2023, Vol. 43 ›› Issue (8): 1338-1347.DOI: 10.3973/j.issn.2096-4498.2023.08.008

Fracturing of an Artificial Rock Mass by Open-Ended Microwave and Potential Benefits to Assisted Mechanical Excavation(开放式微波致裂模拟节理岩体试验及辅助破岩评估)

郑彦龙1，马中骏1，李建春1, *，赵晓豹2

（1. 东南大学土木工程学院，江苏南京 211189； 2. 南京大学地球科学与工程学院，江苏南京 210093）

出版日期:2023-08-20 发布日期:2023-09-11
作者简介:郑彦龙（1988—），男，河南新乡人，2017年毕业于澳大利亚蒙纳士大学，土木工程专业，博士，副教授，主要从事隧道工程和岩石破碎等方向的研究与教学工作。Email： yanlong.zheng@seu.edu.cn。*通信作者：李建春， Email: jcli@seu.edu.cn。

Fracturing of an Artificial Rock Mass by Open-Ended Microwave and Potential Benefits to Assisted Mechanical Excavation

ZHENG Yanlong1, MA Zhongjun1, LI Jianchun1, *, ZHAO Xiaobao2

(1. School of Civil Engineering, Southeast University, Nanjing 211189, Jiangsu, China; 2. School of Earth Sciences and Engineering, Nanjing University, Nanjing 210093, Jiangsu, China)

Online:2023-08-20 Published:2023-09-11

摘要/Abstract

摘要： 为研究开放式微波作用下节理岩体的破裂特征，并评估微波辅助悬臂掘进机的破岩效率，开展微波致裂模拟节理岩体试验。首先，利用9块尺寸为0.5 m×0.5 m×0.3 m（长×宽×厚）的闪长岩岩样垒成1.5 m×1.5 m×0.3 m（长×宽×厚）的人造节理岩体，以模拟节理间距为0.5 m的岩石开挖面；然后，利用6 kW的工业微波系统及缩径介质填充天线对该节理岩体进行微波照射加热致裂试验，研究不同微波照射点间距（15 cm和20 cm）下岩体的破裂特征，分析节理与照射点间距对微波致裂的影响，测量微波处理后岩体的等效岩石质量指标(RQD)和磨蚀性指数(CAI)；最后，基于Bilgin经验模型评估微波照射前后刀盘功率为200 kW的悬臂掘进机的破岩效率和刀具磨损变化。[JP+1]结果表明： 1)2种照射点间距下，岩体的等效RQD从100降低到62和50，微波预处理可使悬臂掘进机在该闪长岩岩体中的破岩效率提高170%～280%； 2）照射点间距为20 cm时，CAI从4.0减少到3.4，可使刀具损耗降低11%。

关键词: 开放式微波, 岩体, RQD, 破岩效率, 刀具损耗

Abstract: In order to investigate the fracturing characteristics of jointed rock mass subjected to openended microwave and estimate the efficiency of microwaveassisted rock breakage by roadheader, tests are conducted on an artificial rock mass under openended microwave. The artificial rock mass (1.5 m×1.5 m×0.3 m) is erected by nine diorite blocks (0.5 m×0.5 m×0.3 m) to simulate a working face with a 0.5 m joint spacing. The rock mass is treated point by point at a spacing of 15 cm and 20 cm, respectively, using a 6 kW microwave source and an openended antenna. The influences of radiation spacing and the distance from radiation to joint on the fracturing of the artificial rock mass are analyzed. The equivalent rock quality designation (RQD) of the microwave treated rock mass is then calculated and the improvement in the rock breakage efficiency of a 200 kW roadheader is estimated based on the Bilgin empirical model. The Crechar abrasivity indexes (CAI) of diorite with and without microwave treatment are measured. The results show that the equivalent RQD is reduced from 100 to 62 and 50 at an radiation spacing of 15 cm and 20 cm, [HJ2.1mm]respectively, and the CAI is reduced from 4.0 to 3.4 at the radiation spacing of 20 cm. Microwave treatment can significantly enhance the rock breakage efficiency of the roadheader by 170%~280%, and reduce the tool wear by 11%.

Key words: open-ended microwave, rock mass, rock quality designation, rock breakage efficiency, tool wear

郑彦龙, 马中骏, 李建春, 赵晓豹. Fracturing of an Artificial Rock Mass by Open-Ended Microwave and Potential Benefits to Assisted Mechanical Excavation(开放式微波致裂模拟节理岩体试验及辅助破岩评估)[J]. 隧道建设, 2023, 43(8): 1338-1347.

ZHENG Yanlong, MA Zhongjun, LI Jianchun, ZHAO Xiaobao.

Fracturing of an Artificial Rock Mass by Open-Ended Microwave and Potential Benefits to Assisted Mechanical Excavation [J]. Tunnel Construction, 2023, 43(8): 1338-1347.

[1]	张坤, 梁庆国, 王尚, 许桐, 周彩贵. 考虑结构面产状的层状岩体引水隧洞围岩精细化评分探讨[J]. 隧道建设, 2023, 43(S1): 198-205.
[2]	刘华吉, 孙红林, 张占荣, 尤明龙, 谭飞, 李炜. 基于随钻参数的砂岩与砂质泥岩地层分界面智能识别[J]. 隧道建设, 2023, 43(S1): 304-312.
[3]	曹勇, 杨川, 仇文革, 王先毫, 白衡斌, 凌鹏. 基于掌子面三维几何图像计算Jv值的方法研究[J]. 隧道建设, 2023, 43(9): 1492-1500.
[4]	姜海波, 张玉洁, 刘雨昕, 惠强. 高应力-渗流耦合作用下不同节理产状对岩体渗流及其塑性区的影响[J]. 隧道建设, 2022, 42(S2): 80-91.
[5]	韩伟锋. 水射流辅助机械滚刀破岩试验研究[J]. 隧道建设, 2022, 42(8): 1414-1419.
[6]	孙希波, 刘宏翔, 李鹏飞, 郭彩霞. 隧道穿越富水断层隔水岩体冲切剪切破坏研究[J]. 隧道建设, 2022, 42(6): 984-993.
[7]	林可夫, 项彦勇. 深埋富水岩体隧道三台阶法施工数值模拟和参数优化——以正盘台隧道工程为例 [J]. 隧道建设, 2021, 41(S1): 199-.
[8]	张宁川. TBM、盾构盘形滚刀硬岩掘进的刃口磨损形状分析及优化对策[J]. 隧道建设, 2021, 41(4): 657-665.
[9]	杨本伟 , 陈相, 林志 , 杨红运 , 郑恩树, 赵天伟. 多物理场耦合作用下裂隙岩体瓦斯迁移规律研究[J]. 隧道建设, 2021, 41(3): 388-395.
[10]	胡其志, 刘倩, 丁志刚, 包文成. 基于Hoek-Brown准则的强度等效方法对比及应用研究[J]. 隧道建设, 2021, 41(10): 1662-1671.
[11]	李涛, 张丽, 蒋庆, 冯春, 赵然. 基于GDEM的隐伏岩溶隧道隔水岩体水压致裂安全厚度及破裂演化规律分析 [J]. 隧道建设, 2021, 41(1): 67-76.
[12]	王法军, 崔亚军, 袁颜彪, 梁广山, 贺鹏. 隧道工程裂隙围岩结构稳定可靠性研究综述[J]. 隧道建设, 2020, 40(S1): 123-137.
[13]	高乔，马克，唐春安，马天辉. 荒沟抽水蓄能电站地下厂房开挖过程微震活动特征与围岩稳定性研究[J]. 隧道建设, 2019, 39(5): 775-782.
[14]	吴亮, 施明, 向晓锐, 陈洋. 地下厂房高应力区节理岩体爆破开挖松动特性研究[J]. 隧道建设, 2019, 39(12): 1949-.
[15]	翟乾智, 周建军, 李宏波, 王利明. 双护盾TBM滚刀磨损及换刀判定案例分析 [J]. 隧道建设, 2019, 39(12): 2081-.

Fracturing of an Artificial Rock Mass by Open-Ended Microwave and Potential Benefits to Assisted Mechanical Excavation(开放式微波致裂模拟节理岩体试验及辅助破岩评估)

Fracturing of an Artificial Rock Mass by Open-Ended Microwave and Potential Benefits to Assisted Mechanical Excavation

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价