• CSCD核心中文核心科技核心
  • RCCSE(A+)公路运输高质量期刊T1
  • Ei CompendexScopusWJCI
  • EBSCOPж(AJ)JST
二维码

隧道建设（中英文） ›› 2014, Vol. 34 ›› Issue (10): 953-958.DOI: 10.3973/j.issn.1672-741X.2014.10.006

• 规划与设计 • 上一篇    下一篇

中隔墙对上海轨道交通16号线大断面盾构隧道的变形影响分析

张中杰1， 叶冠林2， 汤翔1   

  1. (1. 上海市城市建设设计研究总院， 上海 200125； 2. 上海交通大学土木工程系， 上海 200030)
  • 收稿日期:2014-04-10 修回日期:2014-06-26 出版日期:2014-10-20 发布日期:2014-10-24
  • 作者简介:张中杰（1976—），男，上海人，1998毕业于同济大学，工业与民用建筑专业，本科，总院副总工程师，高级工程师，主要从事轨道交通、地下空间与深基坑的设计与研究工作。

Case Study on Influence of Separation Wall on Deformation of Large  Crosssection Shieldbored Tunnel on No. 16 Line of Shanghai Metro

ZHANG Zhongjie1, YE Guanlin2, TANG Xiang1   

  1. (1. Shanghai Urban Construction Design and Research Institute, Shanghai 200125, China； 2. Department of Civil Engineering, Shanghai Jiaotong University, Shanghai 200030, China)
  • Received:2014-04-10 Revised:2014-06-26 Online:2014-10-20 Published:2014-10-24

PDF

1071

摘要：

上海市轨道交通16号线地下区间首次采用内径为10.4 m并设置中隔墙的“单洞双线”大断面盾构隧道。为了避免中隔墙的设置对隧道管片结构产生不利影响，中隔墙顶部与隧道结构之间需预留一定的间隙，即采用分离式设计。针对管片自身重力、地层荷载和地层固结沉降3种不同荷载类型，分别采用弹性铰圆环法、弹性地基梁法和连续介质有限元法计算管片的变形量，讨论隧道管片接头的转动刚度取9 800 kN•m/rad和19 600 kN•m/rad 2种情况。计算结果表明，隧道管片与中隔墙之间的间隙值应取为10~15 cm为宜。

关键词: 大断面盾构隧道, 中隔墙, 管片接头, 转动刚度, 固结沉降

Abstract:

The running tunnel of No. 16 Line of Shanghai Metro is a 10.4 mdiameter singletube shieldbored tunnel with separation wall. Separate design, i.e., some space being reserved between the top of the separation wall and the segment structure of the tunnel, should be adopted, so as to avoid the negative influence of the separation wall on the tunnel segment structure. In the paper, the deformation of the segment ring is calculated by means of elastic hinge ring method, elastic foundation beam method and continuous medium finite element method, considering tunnel segment dead load, ground load and ground consolidation settlement. Two cases, i.e., the rotation rigidity of the segment joints being 9 800 kN•m/rad and that being 19 600 kN•m/rad, are discussed. The calculation results show that the optimum space between the segment and the separation wall should be 10 cm to 15 cm.

Key words: large crosssection shieldbored tunnel, separation wall, segment joint, rotation rigidity, consolidation settlement

中图分类号: 

主办单位：中铁隧道勘察设计研究院有限公司    主管单位：中铁隧道局集团有限公司

本系统由北京玛格泰克科技发展有限公司设计开发 技术支持：support@magtech.com.cn

粤ICP备19038941号